Wiring Diagrams

BEFORE INSTALLING THE ADAPT-TOUCH™ CONTORL

Step 1. Use the pull-chain switch to set the fan speed to the HIGH position before installation. Do not use the pull-chain to change the fan speed after installation, as damage to your ceiling fan or Adapt•Touch™ control may result. The speed of the fan should only be changed

by the Adapt•Touch™ control.

Step 2. Set the ceiling fan light kit to the ON position before installation. The light level should only be changed by the Adapt•Touch™ control.

RECEIVER INSTALLATION PREPARATION

Step 3. Disconnect power to the ceiling fan and light kit at the main electric panel. Remove fuse or move circuit breaker to the OFF position.

Step 4. IMPORTANT! Before installing this control, change the factory default dip switch settings to your own unique code. Be sure the dip switch positions of the transmitter and receiver match, or the ceiling fan will not function. Select different combinations of dip switches to prevent misoperation due to other remote control fans, garage door openers, etc.

Step 5a. If you are installing the remote control with a new fan installation, complete the fan installation according to its instructions, up to the point of installing the Hang•Tru® canopy.

Step 5b. If the fan is already installed, reverse the

installation procedure to remove the ceiling fan and Hang•Tru® canopy from the Crossbar Mounting Bracket.

CONNECTING RECEIVER AND HOUSE WIRING

Step 6. Use the 2 large wire nuts supplied to connect the black and white wires on the top of the receiver to the house wiring. Place each of the bare ends of wire next to each other, then secure with a large wire nut. Test the connection by pulling on the wire nut. (FIG. 2)

• The BLACK receiver wire connects to the BLACK HOT wire in the ceiling outlet box.

• The WHITE receiver wire connects to the WHITE NEUTRAL wire in the ceiling outlet box.

Step 7. Push the wire nuts through the center opening in the Crossbar Mounting Bracket, so they will not

interfere with the canopy and receiver installation. Route the house ground wire and the Crossbar Mounting Bracket ground wire through the hole in the center of the receiver. (FIG. 3)