| ADVAN-TOUCH© CONTROL BRACKET INSTALLATION |
CAUTION! Do not use with wall dimmer.
Standard Light Switch
Step A. Remove the two screws holding the switch cover plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.
Step C. Install and tighten screws by hand only. |
|
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up the two outer mounting holes with those on the switch.
Step D. Install and tighten screws by hand only. |
|
Wall Installation Step A. Locate a 2x4 wall stud in a convenient location.
Step B. Orient the control bracket as shown over the 2x4 stud.
Step C. Use the 1" wood screws in either the inner or outer mounting holes. Install and tighten screws by hand only. |
|
Note: The wall anchors and 6-32 x 1" screws may be used in situations where mounting to a stud is not possible. Use the inner mounting holes. After securing the anchor, discard the anchor's pointed screws and use the 6-32 decor ovalhead screws supplied. |
|
| ADVAN-TOUCH© ATTACHE HOLSTER TO BRACKET |
Step 2
After you have completed installing the bracket to the wall, using the 2 screws removed in Step 1, attach the W-62 holster to the bracket.
Advan-Touch Wall Control - CONTINUED
File Name (SM_FansControls05) RAS 5-11-05
