ADVAN-TOUCH© RMM-6AT PCB Replacement

1. Turn off power at its source (fuse or circuit breaker)

2. Remove blades and blade holders, light fixture and/or switch housing cap.

Circuit Breaker Box
Fuse Box

3. Remove bottom plate and center band.

 

4. To test for a defective RMM assembly, remove the connector (AC/Motor ) by grasping the edges and gently pulling out with a very slight rocking motion.

Plug the connector into a new RMM board. Be sure that the connector and jumper pin positions are aligned and pin #1 is inserted into pin #1. See figure # 1

 


 

To Find a Service Center Near You
Call Toll Free: 1-888-227-2178