Step 1.
Prepare for fan installation as follows:
Step 1A. If the pole was removed from the fan,
route the wires from the motor through the PermaLock
downrod and ball assembly.
|
Tip:
The downrod has a tapered thread that is designed
to lock completely when correctly installed. |
Step 1B. Thread
the downrod into the motor coupling until it stops
turning, this will take at least four and a half full
turns.
Step 1C. Securely
tighten the locking bolt to ensure safe operation
of your fan
| CAUTION: Failure
to fully lock in the downrod before securely tightening
the locking bolt may cause the fan to separate
from the downrod and fall during normal operation! |