WARING: DONOT use these wiring diagram when wiring W-8,W-18,W-28 or W-80 wall controls. This will cause damage to both the PC Board and Wall Control |
Installation is to be in accordance with all National Electrical Code and local codes |
CAUTION! To avoid overheating and possible damage to other equipment, do not install to control receptacle, fluorescent lighting fixture, motor-operated appliance, or transformersupplied appliance.
|
The W-150 is designed to replace a standard wall switch and will fit wall boxes (metal or plastic) with a depth of 2" or greater.
Not for use with fans that use one pullchain switch to control both fan and light.
CAUTION: Ensure power is turned OFF at the breaker or fuse panel before starting installation. |
1. Remove the screws and switch plate from the existing switch box.
2. Remove the screws holding the switch in the switch box.
3. Pull the existing switch from the switch box to expose the wire connections.
4. Remove the two wires from the switch.
|
|
NOTE: The wire connectors provided are suitable for copper wire only. Use to join the following wire combinations: One No. 14 guage with one No. 16 or 18 guage.
6. Connect black lead of control to 120V AC hot wire. Connect the red lead to the light circuit controlled by slider on right side of unit. Connect yellow lead to fan motor(s) wire. The fan speed will be controlled by the left slider on the unit. If unit is used to control only one light circuit, place wire connector on unused lead. Secure these connections with the wire connectors.
7. If a ground wire is provided in your electrical box, attach it to the ground screw near the bottom of the mounting plate.
8. Install the W-150 in the wall box with the two long screws provided.
CAUTION: Be sure no wires are pinched! |
9. Install the wall plate with the two color matched screws.
10.Turn on power to test the controller. |
