W-32 Replacement (Wall Control)

INTELI•TOUCH SINGLE W-32 Installation

CAUTION! Ensure power is turned OFF at the breaker or fuse panel before starting installation.

W-32 is used to describe either White or Ivory finish.

1. Remove the screws and switch plate from the existing switch box.

2. Remove the screws holding the switch in the switch box.

3. Pull the existing switch from the switch box to expose the wire connections.

4. Remove the two wires from the switch.

5. Connect the two wires just removed from the switch to the W-32 wall control black wire and black/white stripe wire. Secure these connections with wire nuts.

6. Install the W-32 in the wall box with the two long screws provided.

7. Install the wall plate with the two color matched screws

NOTE: If your wall control operation is reversed, i.e., fan switch controls lights and light switch controls fan, simply swap the two W-32 black/white stripe wires.

CHECK YOUR WORK:

NOTE: If your wall control operation is reversed, i.e., fan switch controls lights and light switch controls fan, simply swap the two W-32 black/white stripe wires.

Locate the BLUE wire that is wire nutted to BLACK WIRE WITH THE WHITE STRIPE as shown, remove the wire nut. Now locate the BLACK HOT WIRE that is attached to the other BLACK WIRE WITH THE WHITE STRIPE wire, also remove the wire nut. Switch the wire as shown and wire nut them together.

Inteli-Touch Wall Control - CONTINUED

File Name (SM_FansControls05) RAS 5-11-05