6. Install the new BFR by carefully peeling the paper backing off. Make sure that all air pockets have been removed from the BFR and is stuck secured to the motor.

CAUTION: Sharp bending or folding of the BFR will cause damage. Handle with care.

Position one end over the support screw hole, then gently, but firmly, wrap the BFR around the motor, keeping it in alignment so that the holes in the BFR align with the holes on the motor.

7. Reinstall the two screws loosely and slide the Hi-Rel support into place as shown in (Fig 2). Tighten the screws as shown in (Fig 1).

( Fig 1 )

( Fig 5 )