9. Plug the BFR cable connector into the Hi-Rel BFR Header. (Fig 4)

10. Disconnect the LDM assembly (LDM, PCB and pigtail) and remove. (Fig 5) These will not be reused.

11. Plug the LDM connector into LDM Conversion Harness. (Fig 6)

Note: Pin#1 of the LDM Connector must align with Pin #1 of the LDM Conversion Harness.

The black and white wires are now the light fixture supply leads

CAUTION! If a light fixture is not used, cut the bare ends off and install wire nuts.

12. Re-assemble fan body, blade and bladeholders, light fixture and/or switch housing cap.

NOTE: When converting RMM 'FLIK' to HI-REL 'Non-FLIK', a W-32 wall switch MUST be installed. Refer to W-32 installation instructions.