Versa•Touch2©  CONTROL BRACKET INSTALLATION
Wall Installation
Step A. Locate a 2x4 wall stud in a convenient location. Step B. Orient the control bracket as shown over the 2x4 stud. Step C. Use the 1" wood screws in either the inner or outer mounting holes. Install and tighten screws by hand only.


DRYWALL
ANCHOR

 

Note: The wall anchors and 6-32 x 1" screws may be used in situations where mounting to a stud is not possible. Use the inner mounting holes. After securing the anchor, discard the anchor's pointed screws and use the 6-32 decor ovalhead screws supplied.


Decor Ovalhead
screws

Versa•Touch2©  BATTERY INSTALLATION
Remove Battery Door
Turn control on its front. Twist a coin or use your finger to unsnap the door A. Lift door away from control B.

 

Install Battery
Press battery into control aligned as shown.Observe proper polarity. Replace the battery door.


12v BAttery

 

Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the users authority to operate this equipment.
 
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Versa-Touch2 Wall Control - CONTINUED

File Name (SM_FansControls05) RAS 5-11-05




To Find a Service Center Near You
Call Toll Free: 1-888-227-2178