CT_OPforWeb

Comfort Touch Operation

COMFORT • TOUCH © W-21 MOUNTING PARTS

REMOTE CONTROL W-21	REMOTE CONTROL WALL BRACKET	'AAA' ALKALINE BATTERIES (3)	WALL BRACKET ANCHOR (2)
			WALL BRACKET SCREW (2)

COMFORT • TOUCH © W-21 WALL BRACKET INSTALLATION

Installation of Remote Control

The wall mounting bracket for the remote control should be located in a position that is approximately eye level. Secure the wall mounting bracket with the 1¹/4 screws or anchors provided, making sure it is level with the floor.

CAUTION! DO NOT MOUNT REMOTE CONTROL ON OR NEAR A METAL SURFACE - ERRATIC OPERATION WILL OCCUR.

Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user's authority to operate this equipment.

•••

This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

COMFORT • TOUCH © W-21 BATTERY INSTALLATION

Battery Installation

Install three `AAA' alkaline batteries in the sequence shown and replace the battery compartment cover, then press the remote control firmly to the wall bracket so that the Velcro^® pads grip the pads on the rear of the control. The remote control can be easily removed at any time should you wish to use it in another location. Just give the control a gentle tug to remove it.

REMINDER! THE REMOTE CONTROL WILL REVERT BACK TO THE ORIGINAL FACTORY `PRESET CHANNEL' NUMBER WHEN THE BATTERIES ARE CHANGED. CHANGE CONTROL CHANNEL IF NECESSARY AFTER BATTERY REPLACEMENT.

Low Battery Indicator

The remote control warns of a low battery condition by displaying a rapidly flashing `Lo' in place of the temperature display. When this occurs replace with fresh alkaline batteries.

WARNING: Use of batteries other than non-leak sealed alkaline in the remote control will void the warranty and can destroy the unit.

Note: When the remote is in the low battery mode the fan may not respond to control commands correctly even though the fan may be running.