Turning On Your Fan
The fan will not receive any signals for the first 20 seconds after power on. This allows the electronics to warm up and stabilize. Power Failure The remote control is not affected by household power failure as it is battery operated. Once power is restored to the fan it will receive an auto-update signal from the remote control within 30 minutes after power is restored. All previously set modes and functions will be restored to the fan. Button Operation Rapid button pressing causes erratic fan operation. For reliable operation of the remote control and fan you must wait ONE SECOND between button presses to allow the radio signal to be transmitted to the fan and received.

Labeling:

If you have more than one Comfort•Touch fan in your home, we suggest you put an adhesive room identification label on the back of the control. Labels are in the remote control package.

General:
Your Comfort•Touch remote control uses one of 15 different radio signals to control the fan. This channel is set at the factory. There may be times when the channel needs to be changed,i.e.:

Press the TEST button to activate a two minute program that puts the fan through a complete functional test. The test starts with a full screen display, then the 'preset' channel number before going into a full light, fan and reverse exercise. Follow the remote control LCD display and compare it to the actual fan operation to confirm correct operation.

The Comfort•Touch fan is controlled by the remote control. The fan is turned on and off by alternate pushes of the large right hand button. As with all button operations, an audio tone sounds with each push. With the fan on, the control display will indicate an up or down moving arrow that shows direction and places a box around the operating speed. The two small UP and DOWN buttons below the fan button increase or decrease speed once for each press.

The light is turned on and off by alternate pushes of the large left hand button. When on, the display will indicate the light bulb symbol and a vertical segment display representing brightness. When the light is on, the brightness may be changed by using the small UP and DOWN buttons below the light button. Pressing and holding either button will change the brightness continuously. Bulb-Saver Feature When the light is turned on, the brightness is gradually increased until it reaches the preset level. This feature helps extend light bulb life.

Additional control program features are available from the control panel by opening the control panel door. To activate a control function press the appropriate button; the display will indicate that the program is running.