To turn the lights off and on, press and release the button for less than one second.

To vary the light brightness:

1. With lights off, press and hold the button. After one second the lights come on at their lowest level and gradually become brighter.

2. Release the button when the desired brightness level is reached.

The brightness level is now in the fan memory and will automatically come on at the same brightness the next time the button is used. To maintain this level of brightness, press the button for less than one second. To lower the brightness, turn the lights off, then press and hold the button until the desired brightness level is reached. When the light is on, you may increase the brightness level by pressing and holding the button until the desired level is reached, then release it.

Programmed into every Inteli-Touch Series fan is an Au-tomatic Demonstration Program. It can be used to fully demonstrate and test the operation of the fan.

To enter the demonstration program:

1. Turn POWER off for at least three seconds. This will clear the fan memory ready for programming.

2. Turn POWER on.

3. Immediately operate the buttons in the following se-quence:

The Light-Minder program automatically turns OFF the fan mounted lights after two hours.

To enter the Light-Minder Program:

1. Turn the POWER OFF for at least three seconds.

2. Turn the POWER ON.

3. Immediately operate the buttons in the following sequence:

+ + +

4. A series of tones indicates this command has been accepted.

The fan and light will operate normally using the buttons to turn them on and off. But, if the lights are left on, they will automatically shut off after two hours. To cancel the Light-Minder Program, turn the POWER off for three seconds.