Adapt•Touch™

Page 4 of 5



Page:
       

CONNECTING RECEIVER AND HOUSE WIRING

Step 8. Place the Adapt·TouchTM receiver in the Hang·Tru® canopy with the receiver open side facing the canopy opening. The receiver will align itself on the screw openings in the bottom of the canopy.

Step 9. Refer to the "Canopy Installation" section of the ceiling fan manual for directions on installing the canopy screws and lock washers. (FIG. 4)

NOTE: Do not allow wires to be pinched between the edge of the Crossbar Mounting Bracket and Receiver.
Step 10. Refer to the "Hanging the Fan" section of the ceiling fan manual for directions on hanging the fan inside the canopy. Note that the Blue wire of the fan should NOT be capped, as the Adapt·TouchTM will use this wire for light control.


TIP: When aligning the canopy to the bracket, install the canopy screw through the canopy opening first. Install the other three canopy screws. Then remove the canopy screw for use in Step 14.
CONNECTING RECEIVER AND HOUSE WIRING

Step 11. Run the antenna through the top hole of the dowered as shown.

NOTE: Failure to run the antenna through the down rod may result in reduced operating range.

Step 12. Use a large wire nut to connect the house ground to the Mounting Bracket ground wire and ceiling fan ground wire.

Use the 3 small wire nuts supplied to connect the 3 receiver wires to the 3 fan wires. Each wire is color coded to match the fan. Place each of the bare ends of wire next to each other, then secure with a large wire nut. Test the connection by pulling on the wire nut. (FIG. 5)

· The BLACK fan output wire connects to the BLACK fan wire

· The BLUE light output wire connects to the BLUE light wire.

· The WHITE common wire connects to the WHITE neutral wire in the ceiling outlet box.

Step 13. Tuck all the wiring back into the canopy, leaving space for the canopy hatch screw to pass through without interfering with the wires.

Step 14. Refer to the "Canopy Hatch Installation" section of the ceiling fan manual for directions on installing the canopy hatch.

Step 15. Finish the fan installation or reinstallation by securing the fan brackets, blades, and light kit. Refer to the ceiling fan and light kit instructions for more information.


NOTE: Confirm that the DIP switch settings on the receiver match your transmitter's DIP switch settings before installing the canopy hatch.


Page:
       

To Find a Service Center Near You
Call Toll Free: 1-888-227-2178