VERSA-TOUCH OPERATION

VERSA • TOUCH © CONTROL HOLDER INSTALLATION

CAUTION! Do not use with wall dimmer.

Standard Light Switch

Step 1. Remove the two screws holding the switch cover plate. Do not remove the cover plate.

Step 2. Orient the control holder as shown and line up the two inner mounting holes with those on the switch.

Step 3. Install and tighten screws by hand only.

Rocker Light Switch

Step 1. Remove the two screws holding the switch cover plate. Do not remove the cover plate.

Step 2. Break off the the two tabs by pushing outward.

Step 3. Orient the control holder as shown and line up the two outer mounting holes with those on the switch.

Step 4. Install and tighten screws by hand only.

VERSA • TOUCH © HOLDER INSTALLATION / STORAGE

Wall Installation

Step 1. Locate a 2x4 wall stud in a convenient location.

Step 2. Orient the control holder as shown over the 2x4 stud.

Step 3. Use the 1" wood screws in either the inner or outer mounting holes. Install and tighten screws by hand only.

Note: The wall anchors and 632 x 1" screws may be used in situations where mounting to a stud is not possible. Use the inner mounting holes. After securing the anchor, discard the anchor's pointed screws and use the 632 decor ovalhead screws supplied.

Anchor
panhead
screw

DRYWALL ANCHOR

WOOD
SCREW 1"

Wall Controls - CONTINUED