Wall Controls - CONTINUED
W-500™
W-500™ CONTROL BRACKET INSTALLATION

Wall Installation

Step A. Locate a 2x4 wall stud in a convenient location.

Step B. Orient the control bracket as shown over the 2x4 stud.

Step C. Use the 1" wood screws in either the inner or outer mounting holes. Install and tighten screws by hand only.


DRYWALL ANCHOR

 
Note: The wall anchors and 6-32 x 1" screws may be used in situations where mounting to a stud is not possible. Use the inner mounting holes. After securing the anchor, discard the anchor's pointed screws and use the 6-32 decor ovalhead screws supplied.


Decor Ovalhead screws


Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user's authority to operate this equipment.

 

This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

W-500™ BATTERY INSTALLATION

Remove Battery Door

Turn control on its front. Twist a coin or use your finger to unsnap the door A. Lift door away from control B and remove C.

 

Install Battery

Press battery into control aligned as shown.Observe proper polarity. Replace the battery door.

Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void the user's authority to operate this equipment.

 

This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Wall Controls - CONTINUED


P. 2
To Find a Service Center Near You
Call Toll Free: 1-888-227-2178