WARING: DONOT use these wiring diagram when wiring W-18 or W-28 wall controls. This will cause damage to both the PC Board and Wall Control
The fan may be turned ON and OFF by the W-80 wall control.
The lights may be turned ON and OFF by the W-80 and the intensity adjusted from low to high.
The fan must be supplied with two independent 120V AC supply wires.
Set the FAN pull chain switch to the HIGH speed setting.
Turn the lights ON at the fan.
The W-80 allows the choice of four (4) different speed settings.
CAUTION! Failure to set the pullchain speed to HIGH can result in faulty operation of the fan and damage to the W-80 wall control. To confirm fan is set to HIGH: Turn W-80 fan speed switch to `HI' - set fastest fan speed with pull chain.
To Find a Service Center Near You
Call Toll Free: 1-888-227-2178
